How to use

Watch The Full Tutorial On How to Use Holwah Skincare System:  

Written Steps: 

1- Prepare & Clean: 

  • Remove your makeup before holwah microcurrent treatment. 
  • Do not wear a necklace and tie up your hair very well.
  • Clean and dry your face with a water-soluble cleanser.
  • Apply the conductor serum/ gel and make sure it’s a water-soluble base and doesn’t contain oil. This will help in better gliding of the strobes in addition to better conductivity.
  • Turn on the device and choose the preferred level.
  • Glide the device in the outer movements of the face and on top of a clear moist skin area.

2- Activate & Lift

  

 

  • Start with the neck as in the picture in 3 vector areas, from the lower neck to the upper part.
  • Each glide should take 3 to 5 seconds, stop for 1 second, at the end

    •  

    • Go up and start with the jawline, then, cheeks, then, below the eyes. Always repeat gliding 3 times per movement.
    • Each glide should take 3 to 5 seconds, stop for 1 second, at the end.

    • Lift the forehead in the upper direction
    • Each glide should take 3 to 5 seconds, and stop for 1 second at the end.

    • Lift the side of your face from near your eyes towards your hair
    • Each glide should take 3 to 5 seconds, stop for 1 second at the end

    Repeat the same movements to the second half of the face starting from the neck up towards the forehead

    3- Finish & Boost

    • Tap on your face until the serum dries, no need to cleanse your face again.
    • Continue with your morning routine or night routine skincare applications.
    • Your skin is ready to absorb any skincare product now.
    • Do not wash the device with water, just wipe it with a dry towel

     

    While using the device on Level 2 or Level 3

    • If you want to turn on the microcurent feature, you should use it either on level 2 or level 3, level one is just heat. 
    • You must use it on top of a gel or serum before your face dries to enhance the conductivity on your skin.
    • Feeling the pulses on your face is not mandatory, but usually while using it on level 3, you will feel the electric pulse-like tingling on your face. This is normal.
    • Adjust the level as per your convenience, but we always suggest reaching level 3 after a few days of using it